|World Discussion Forums  |
Add to Favorites Digg It
Small Engine Repair Forum
Carbartor needs cleaning. Most small engines are not run very often such as seasonal equipment and the ports get cloggend up.
On B+S snowblower I undid the linkage by taking off governor screw. Cleaned carb and float valve area. Now only runs on half or full choke. Idles high. How do I know how to set that governor screw and the linkage to it so things run smoothly again??
[Posted from : UNITED STATES]
8/7/11 10:15:53 AM
Loosen the screw that holds the governor arm. Hold throttle lever to full throttle, hold governor arm still and turn governor shaft the same way as throttle lever as far as it goes, then tighten governor arm. Three hands are helpful! Make sure that your muffler is not clogged. Check fuel filter, fuel line. hole in bottom of gas tank for debris
|Print Tweet||Topic 19 of 297|
| Your reply here... [Please stay on topic. Previously spammed affiliate links may have referrer removed.]|
Your Avatar: (optional)
[Avatar must be available on the web. Enter its URL above then click 'Get It'. Maximum
image size is 150x150 pixels. Your Facebook pic can be used with this method. You can get
your Facebook avatar URL by opening Facebook, right-clicking your pic and selecting 'Properties'.
Your pics URL/address will be shown. Copy it, then paste it here and click 'Get It'.]
Email me when new replies are posted to this topic
(Optional. Not displayed.)